After setting your clock press the small button labeled dst normally located just above and between the et and ct time zone buttons on the back of the clock for one second.
Sharp atomic wall clock change time zone.
Manual can be found here.
Then set the bottom switch back to run.
Press the mode to return to the time mode position.
Getting an atomic clock back in time is a piece of cake.
Then push the yr 12 24 button until you get the correct time zone.
When they lose their time or take on a slow tic toc it can be frustrating.
Setting the time zone in the normal time display press the mode button to enter the alarm time mode.
If the clock has and buttons on the front of the clock pressing and holding the button will move the dark.
The latest in digital analog alarm and wall clocks from sharp offer state of the art technology and high quality product design to enhance lifestyles.
How do you change the time zone in your sharp atomic clock model spc384.
Press the time button o n c e t h i s enters the.
Refer to the time zone map on the display p pacific m mountain c central and e eastern.
Atomic clocks are impressive and precise.
You will see the month date area change to the alarm area.
There is only one sharp.
Press the set button to set the desired time zone.
P pacific m mountain c central e eastern.
If your location is not in the pacific set the time zone by pressing wave button to change the pacific time mountain time central time eastern time zone in the normal time mode and will disappear after setting.
Refer to the time zone map on the display p pacific m mountain c central and e eastern.
Press the set button to set the desired time zone.
Press the up button to select the proper time zone.
Atomic clocks adjust for daylight saving time so if your area doesn t observe dst like the state of arizona you must disable the dst function.
The default time zone is pacific.
There is only one you.
Repeat the process to set the date hour minute and second.
If your location is not in the pacific set the time zone as follows.
When the sharp spc900 is not able to receive a signal from the atomic clock it is possible to temporarily set the clock s time manually.
To do so one should press and hold the time button on the back of the clock until the year digits appear then use the up and down buttons to change its values.
Then press the time button again to move to the month digits.
The default time zone is pacific.